Inventory Listing

We are proud to present one of Henry’s masterpieces from Intermeccanica. ABSOLUTELY no expense spared and it shows in the end product just over 104,000 USD spent on the build.

Donor car was a 1980 911 SC with 12000 miles sourced.3 litre. Engine rebuilt with Webber PMO Carbs Transmission, suspension, brakes are used. M and K exhaust with SSi heat exchangers finish this the under carriage. This part was just over $40,000 USD

Intermecannica Build

1. Intermeccanica Speedster 6 Coach is a custom built high quality “Hot Rod” version of 1959 Porsche 356 A Carrera Speedster, featuring in-house designed and built tubular steel perimeter tube chassis, designed to be built up using Porsche 911 1969 and newer front and rear suspension, brakes steering and 911 6-cylinder engine/transaxle package.
   Base price $38,010

Standard Features – Mechanical

• Large section tubular steel frame integral with fiberglass body to use any 911 engines/transaxle package up to 1986/915 transaxle
• Designed for the use of stock 911 front suspension. Coach includes a pair of Intermeccanica camber/caster adjusting plates using spherical bearings, giving a wide range of adjustment and precise location of the top of the strut. Turbo steering tie-rod assemblies are required
• Use stock 911 long wheelbase rear suspension (1969 and later). Supplied with the coach are special radius arms. The engine/transaxle unit is moved forward in the chassis by approximately 3” (75mm). Use of 21 ¾” length torsion bars (26/28mm. recommended)
• Other mechanical features include Intermeccanica inboard torsion bar adjusters to adjust rear ride height. Camber adjustment is provided at rear control arm pivot
• Suggested front wheels stock 911 6” with 112mm of backset. Suggested rear wheels 7” with 138mm of back set (911R). 3m-6mm spacers rear will be required for proper clearance and geometry. Custom wheel fabrication/modification is available

Standard Features – Body

• Glasurit urethane paint, base/clear
• Color: Fashion Gray
• Code: R531CS
• Reproduction Porsche Speedster bucket seats (see note under ‘Special Instructions’) Piping color: To match
• Glass side windows, power with hidden switches
• Original smooth door panels
• Chrome plated windshield frame and hood handle
• Exterior door handles with lock-in push buttons
• Carpeted trunk, standard black
• Third brake light
• Original heater slides

Options – Mechanical

• Mechanical Premount Package Number 1 – $1090
  • Including all parts listed below installed:
  • Pedals, brakes Master Cylinder, Brake Fluid Reservoir, Handbrake, Handbrake Cables, Accelerator Cable, Battery Cable, Clutch Cable, all Hard Brake Lines, Fuel Line or Lines
• Mechanical Premount Package Number 2 – $700
  • Including all parts listed below installed:
  • Wiper Motor Assembly, Wiper Arms with Blades, Electric Windshield Washer Fender mounted remote tank to maximize trunk space
• Mechanical Premount Package Number 3 – $1980
  • Including all parts listed below installed:
  • Steering Column Assembly including all parts listed: IM Custom Steering Head, Turn Indicator Switch, Double Universal Joint Shaft, Turbo Tie-Rod Kit for Steering Rack
• Fuel Safe racing fuel cell, 15 gallon, (58lt.) full foam baffling with special fuel sender and internal fuel pump. All SST lines, custom front trunk (special price) – $2095
• 27mm rear torsion bars – $460
• Install customer supplied suspension set, including wheel alignment/ corner weight set and final adjustment of wheel fit. – $2410

Options – Body

• Full leather interior, approx. 115 sq.ft.   – $1490
• (with Speedster bucket seats)
• Color: Tuscany
• Code: VO 963
• (Special price – normally $1840)
• Original square weave carpeting – $990
• Color: Light Grey
• Code: 701
• Binding (included) for square weave carpeting
• Color: Matching
• Material: Original Cotton
• Dual range seat heaters, both seats, switches mounted on center console behind shifter – $685
• Original style dash and door panel trim – $245
• All original Beige interior trim – $180
• “Carrera” louvered rear deck lid – $650
• Custom fitted floor mats, Cocomats #53 – $385
• Front quarter panel storage bins, pair, (carpet on outside, leather on inside) – $180
• Custom made exact 356 instrument set with 8000 RPM tachometer, 160 MPH speedometer, oil temperature gauge and fuel level gauge – $1630
• Rear reflectors – $245
• Grab handle on dash – $110
• Courtesy lights – $265

Special Instructions and Equipment:

• Haartz Stayfast “G” cloth top original low bow with fully articulated original style top frame, Tenax fasteners (Special price – normally $480) – $300
• Color: Black/Beige
• Code: 1821
• Apply zipper to rear window panel on top, (add’l cost only) – $102
• Full tonneau cover in matching Haartz Stayfast “G” – $780
• Custom Speedster bucket seats to be fabricated with one inch increase in width for improved fit and comfort. Lumbar support added to seat. Seat base foam to be made as low profile as possible for best customer fit (special price – normally $750) – $450
• Crow 3”, 2-point safety belt system, snap-in belt anchors – $200
• Cigar lighter, mounted right in center console, pointing up – $40
• “Carrera” body trim package, delete side molding and rocker molding – ($170)
• “Carrera” bumpers with correct polished aluminum deco strip – $650
• Mocal dual oil cooler including 235 matrix cooler and matching thermostat, all Dash 12 lines – $1480
• Supply & install high angle CV joint shafts, McKenzie’s CV’s, EMPI shafts, boots and plates, Fabory bolts and washers – $1310
• High performance Optima battery – $190
• Set SST brake hoses – $150
• Installation set-up of customer supplied 911 engine and transaxle (complete), invoiced by the hour, 53hrs @ special rate of $55/hour – $2915
• Install set customer supplied driving lights with chrome back, approximately 160mm (6-1/4”) diameter; fabricate custom bracket mounts independent of front bumper. Locate switch in “Carrera” dash location right, wire switch with relay to operate with high beam – $230
• Fabricate umbrella hand brake bell crank and install customer supplied hand brake assembly, supply additional parts as necessary – $480
• Install customer supplied steering wheel, supply and machine adapters and hubs, supply and install ‘Fellman’ 356 horn button with IM crest (cost & labor only) – $680
• Install set Bilstein shock absorbers, front and rear – $480
• Fill and service engine with special VR1 racing oil (at cost) – $158
• Supply and install 356A “mushroom style” shift knob – $20
• SafeCraft clean agent (Halon) Engine compartment fire suppression system (at cost) – $381
• Fabricate “functional” rubber covered dead pedal
• Full under side of body to be coated in black bead liner conversion coating (special offer standard price $695)
• Original style steering column with 356 style signal switch with high beam/low beam trigger
• Rear fender openings to be dropped 5/8” to provide appearance of lower stance but still retain excellent ride quality. All fender openings to be custom finished to original “rolled” fender edge appearance (special offer – standard price $1170)
• Supply and install 108mm drive flanges on transaxle
• Install customer supplied floor mounted heater control
• Supply and install GT fender mounted mirror including paint, fit with customer present
• No front floor mats, Coco mats only
• Paint shifter shaft silver color
• Delete interior lock knobs
• Delete switch knob labels
• Relocate hazard light switch to “Carrera” dash position left
• Install customer supplied European 356 H4 headlights, including dual relay power supply
• Install customer supplied front signal lights
• Install customer supplied red teardrop LED conversion tail lights with original style 2” power wire set-up

Pricing Summary

1. Base price: $38,010 USD
2. Total Options: $15,790 USD
3. Total Special Equipment: $10,826 USD
4. Additional charges (cost only): Parts import brokerage: $102 USD
5. Less Parts Transport Charges: ($600USD)

Subtotal: $64,128 USD

This is an amazing piece and she’s yours for $110,000 USD